Plastic granule cutters play a vital role in the plastics processing industry, as they are responsible for cutting raw plastic pellets into particles of the desired size. However, over a long period of time, plastic decalcifying machines may encounter some faults that affect productivity and product quality. In this article, we will introduce the common faults in the operation of plastic dana cutter and the corresponding solutions.

Problems that may occur in plastic granule cutter

• Knife wear: Plastic granule cutter after a long time running, the knife will be gradually worn because of the friction with the plastic. Serious wear and tear of the knife will lead to the emergence of cutting is not clean, particle size inconsistency and other issues, and even not cut plastic, affecting production efficiency.
• Electrical failure: The plastic dana cutter machine in the use of the process may be electrical failure, such as power line short circuit, motor failure and so on. These electrical failures will lead to the machine can not start or stop normally, affecting the continuous operation of the production line.
• Feed blockage: Waste plastic cutter machine in the processing of plastic, sometimes because the plastic block is too large or feeds too fast and leads to the feed port blockage. Feed port blockage will make the granulator can not run normally, need to stop to clean up, affecting production efficiency and continuity.

Methods to solve the failure of plastic cutter machine

• Regularly check the tool wear and replace the badly worn tool in time to ensure cutting efficiency and quality. At the same time, set the tool spacing and speed reasonably to reduce tool wear.
• Regularly check the electrical system of plastic granule cutter, including wiring, switches, sensors and other components, to ensure that they are firmly connected and free of short-circuit and leakage. Regular maintenance of the electrical system is recommended to repair or replace aged or faulty electrical components in time.
• Strengthen the monitoring of the feeding system and pay attention to the shape, size and humidity of the plastic granules to avoid clogging due to oversized granules or high humidity. In addition, clean the feeding pipes and bins of plastic granule cutter regularly to ensure that the bins are unobstructed and prevent clogging problems caused by the accumulation of residues.